Cabletron Systems 9C706 Installation Guide download pdf (Page 23)

2-5

SmartSwitch 9000-6 Slot Chassis Installation

Installing a Power Supply

At least one power supply must be installed on the front of the SmartSwitch 9000-

6 Slot chassis. An additional power supply can be added to achieve redundancy.

A power supply is installed by plugging it into either the left or right power

supply slot on the front of the SmartSwitch 9000-6 Slot chassis, as shown in

Figure 2-2.

Install a power supply by following the steps below:

1. Unpack the power supply by removing it from the shipping box and sliding

the two foam end caps off the unit. (Save the shipping box and packing

materials in the event the power supply must be reshipped.)

2. Remove the power supply from the protective plastic bag. (Save the bag in the

event the power supply must be reshipped.)

3. Examine the power supply carefully, checking for damage. If any damage is

noted, DO NOT install the power supply. Contact Cabletron Systems

immediately.

4. Hold the power supply by the handles and do the following:

a. Align the power supply so that the guide rails on the top and bottom of

the power supply align with the rail tracks on the inside of the chassis.

b. Slide the power supply into the chassis.

Only qualiÞed personnel should perform installation procedures.

Read the section, Installation Requirements, in this chapter before completing the

following procedure.

CAUTION

Forcing a misaligned module into place can damage the module and/or the chassis

backplane.

CAUTION

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

Cabletron Systems 9C706 Installation Guide Page 23