Cabletron-systems ELS10-26TX User Manual

Getting Started with the SmartSTACK 10 ELS10-26 ELS10-26TXSTATUSPORT STATUS MODE10BASE-T/100BASE-TXFEPIM2X 4X 6X 8X

– 4 – Connecting UTP Cables Before connecting a segment to the ELS10-26, check each end of the segment to verify wire crossover.Connect a twisted pa

– 5 – Installing a Fast Ethernet Port Interface Module (FEPIM) The ELS10-26 provides a slot for a Cabletron FEPIM (Fast Ethernet Port Interface Modul

– 6 – Connecting a UTP Segment to FE-100TX An FE-100TX is often used to provide a connection between the ELS10-26 and a bridge, router, or switch. Of

– 7 – Connecting a Multimode Segment to the FE-100FX The FE-100FX has an SC style network port. Cabletron Systems supplies fiber optic cable that use

– 8 – Connecting the Local Console Manager to a Terminal The Local Console Manager (LCM) is a command-line interface for configuring, monitoring, and

– 9 – LCM Commands addresses display Displays learned addresses.Options:anyADDRESSMASKExample: address display anyarp display Displays the ARP table

– 10 – exit (logout) Allows you to log out of your current LCM session.Example: exithelp Displays the available LCM commands. You can also type a

– 11 – sttimer Displays the current Spanning Tree Address Table aging time, and allows you to enter a new aging time.Example: sttimer

– 12 –

– i – NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior not

– ii – CABLETRON SOFTWARE PROGRAM LICENSE 1. LICENSE. You have the right to use only the one (1) copy of the Program provided in this package subject

– iii – Contents Welcome to SmartSTACK 10 ELS10-26 ... 1

– iv –

– 1 – Welcome to the SmartSTACK 10ELS10-26 This Getting Started Guide will tell you what you need to get your SmartSTACK10 ELS10-26 up and running, o

– 2 – Setting Up and Powering Up the ELS10-26 Setting up and powering up your ELS10-26 is a simple process that requires you to:• attach the power co

– 3 – 4. All Port Status lights remain on.5. All Link LEDs flash, four at a time, in sequence, from left to right.6. After several more seconds, the C