CHAPTER 2: LOCAL MANAGEMENT
2-8 WPIM-SY LOCAL MANAGEMENT GUIDE
2.3 PPP CONFIGURATION
This section provides step-by-step instructions for connecting the
WPIM-SY to a DDS (Digital Data System) circuit in a PPP environment.
This example assumes the setup shown in Figure 2-3 using two
MicroMMAC hubs with WPIM-SY modules installed in each BRIM-W6.
Figure 2-3. WPIM-SY Interface Configuration for PPP
The line configuration information shown in Table 2-1, “Telco
Configuration Information,” on page 8 must be supplied by the service
provider.
Table 2-1. Telco Configuration Information
Configuration Information
Required By User
Configuration Information
Supplied By Service Provider
Clock Source Telco provided or no clock source
Circuit Speed 64K, V.35, RS-422, RS-232, etc.
Telco Cloud
CSU/
DSU
CSU/
DSU
MicroMMAC #2
with BRIM-W6
SITE #2
MicroMMAC #1
with BRIM-W6
SITE #1
1483_03
Comments to this Manuals