Cabletron Systems 2208 User's Guide download pdf (Page 141)

Removing the Chassis Cover

2H28-08R SmartSwitch 2208 User’s Guide C-3

2. If the 2H28-08R is rack mounted, remove it from the rack and remove

the rackmount brackets (refer to Chapter 3, Optional Installations

and Mode Switch Bank Settings).

3. Use a Phillips screwdriver to remove the screws attaching the cover to

the chassis. (See Figure C-1.)

4. Remove the cover by sliding it back until it clears the front of the

chassis and then lifting it straight up and off the chassis.

To reinstall the chassis cover, perform the removal procedures in reverse.

Figure C-1 Removing the Chassis Cover

2251-30

Chassis Cover

Chassis

Cover Screws (7)

Note: If the device was rack mounted, the four screws fastening the cover to

the front panel are removed and installed along with the rackmount brackets.

Front Panel

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 151 152

No comments

Cabletron Systems 2208 User's Guide Page 141