Cabletron Systems SSIM-R8-02 Specifications download pdf (Page 29)

Enterasys Xpedition User Reference Manual 9

Activating the Configuration Changes and Saving the Configuration File

The show and system show commands display the commands in the order they were

executed. You can change this sequence to alphabetical order by using the system set

show-config command.

Activating the Configuration Changes and Saving the

Configuration File

Activating the Configuration Commands in the Scratchpad

The configuration commands you have entered using procedures in this chapter are in the

Scratchpad but have not yet been activated. Use the following procedure to activate the

configuration commands in the scratchpad.

1. Ensure that you are in Enable mode by entering the enable command in the CLI.

2. Ensure that you are in Configure mode by entering the configure command in the

CLI.

3. Enter the following command:

The CLI displays the following message:

4. Type y to activate the changes.

Note: If you exit the Configure mode (by entering the exit command or pressing

Ctrl+Z), the CLI will ask you whether you want to make the changes in the

scratchpad active.

Saving the Active Configuration to the Startup Configuration File

After you save the configuration commands in the scratchpad, the control module

executes the commands and makes the corresponding configuration changes to the XP.

However, if you power off or reboot the XP, the new changes are lost. Use the following

procedure to save the changes into the Startup configuration file so that the XP reinstates

the changes when you reboot the software.

1. Ensure that you are in Enable mode by entering the enable command in the CLI.

save active

Do you want to make the changes Active? [y]

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 393 394

No comments

Cabletron Systems SSIM-R8-02 Specifications Page 29