Cabletron Systems SSIM-R8-02 Specifications download pdf (Page 49)

Enterasys Xpedition User Reference Manual 29

Hot Swapping a Secondary Control Module

When you press the Hot Swap button, all the LEDs on the Control Module (including

the Offline LED) are deactivated. Figure 3 shows the location of the Offline LED and

Hot Swap button on a Control Module.

Figure 3. Location of Offline LED and Hot Swap Button on a Control Module

You can also use the system hotswap out command in the CLI to deactivate the Control

Module. For example, to deactivate the secondary Control Module in slot CM/1, enter the

following command in Enable mode:

After you enter this command, the Offline LED on the Control Module lights, and

messages appear on the console indicating the Control Module is inoperative.

Removing the Control Module

To remove a Control Module from the XP:

1. Make sure that none of the LEDs on the Control Module are lit.

2. Loosen the captive screws on each side of the Control Module.

3. Carefully remove the Control Module from its slot in the XP chassis.

Installing a Control Module

To install a new Control Module or line card into the slot:

Note: You can install either a line card or a Control Module in slot CM/1, but you can

install only a Control Module in slot CM.

1. Slide the Control Module or line card all the way into the slot, firmly but gently

pressing it in place to ensure that the pins on the back of the card are completely

seated in the backplane.

Note: Make sure the circuit card (and not the metal plate) is between the card

guides. Check both the upper and lower tracks.

10/100 Mgmt

Console

RST

SYS

ERR DIAG

HBT

Hot

Swap

Online Offline

Hot Swap Button

SSR-CM2 CONTROL MODULE

Offline LED

ssr# system hotswap out slot 1

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 393 394

No comments

Cabletron Systems SSIM-R8-02 Specifications Page 49