Cabletron Systems BRIM-E6 Specifications download pdf (Page 22)

FULL E-1 CONFIGURATION USING PPP

WPIM-E1 LOCAL MANAGEMENT GUIDE 2-13

3. If the E1 Line Coding is HDB3 on the previous screen:

a. Use the arrow keys to highlight Line Coding. Press the

SPACEBAR to select None, then press ENTER.

b. Use the arrow keys to highlight Active Protocol. Press the

SPACEBAR to select PPP, then press ENTER.

c. Use the arrow keys to highlight PPP Type. Press the SPACEBAR

to select BNCP, then press ENTER.

4. If the E1 Line Coding is AMI on the previous screen:

a. Use the arrow keys to highlight Line Coding. Press the

SPACEBAR to select INV-HDLC, then press ENTER.

b. Use the arrow keys to highlight Active Protocol. Press the

SPACEBAR to select PPP, then press ENTER.

c. Use the arrow keys to highlight PPP Type. Press the SPACEBAR

to select BNCP, then press ENTER.

5. Use the arrow keys to highlight the SAVE command, then press

ENTER. The message “Save Done!” appears and Local Management

saves the changes to memory.

The WAN conﬁguration is complete. It takes up to 60 seconds for the

WAN Interface to come out of standby and for communications to begin.

Upon saving this screen, the interface just configured is

assigned to an application port (PT#) in the table on the right

hand side of the screen.

NOTE

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

No comments

Cabletron Systems BRIM-E6 Specifications Page 22