Cabletron Systems BRIM-E6 Specifications download pdf (Page 29)

CHAPTER 2: LOCAL MANAGEMENT

2-20 WPIM-E1 LOCAL MANAGEMENT GUIDE

4. Use the arrow keys to highlight E1 Line Coding. Press the

SPACEBAR to select HDB3 or AMI, then press ENTER.

5. Use the arrow keys to highlight E1 Frame Type. Press the

SPACEBAR to select E1 or E1-CRC, then press ENTER.

6. Use the arrow keys to highlight E1 Tx Clock Source. Press the

SPACEBAR to select Local (no clock source provided by telephone

company) or Loop (clock source provided by telephone company),

then press ENTER.

7. Use the arrow keys to highlight the SAVE command, then press

ENTER. The message “Save Done!” appears and Local Management

saves the changes to memory.

8. Access the WAN Interface Configuration screen by using the arrow

keys to highlight the WAN Int Config option and then press ENTER.

The value assigned to the Timeslots is the interface being used

for WAN communication. The available interface range is

displayed on the WAN Physical Configuration screen (see

Figure 2-1). You may insert any of the available interface

numbers into the Timeslots.

In the example shown in Figure 2-1, the interface range for

the MicroMMAC with a WPIM-E1 in slot one of the

BRIM-W6 is 2-33. Although any of these values may be used,

Cabletron Systems recommends using the first available

interface number (in this example interface #2).

The following three steps are based on information supplied

by the service provider. Consult the service provider for the

correct settings.

NOTES

If you are using a Local clock source, set only one end of the

circuit for Local, the other end must be set for Loop.

CAUTION

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

No comments

Cabletron Systems BRIM-E6 Specifications Page 29