Cabletron Systems BRIM-E6 Specifications download pdf (Page 26)

FRACTIONAL E-1 CONFIGURATION USING PPP

WPIM-E1 LOCAL MANAGEMENT GUIDE 2-17

2.4.2 WPIM-E1 Interface Conﬁguration

This screen is accessed through the WAN Physical Conﬁguration screen.

Proceed with the following steps to conﬁgure the WAN Interface through

Local Management.

1. Set the WAN connection Interface Number by typing the same

number into the Interface Number field that was input into the

Timeslots in the WAN Physical Configuration screen, then press

ENTER. (see NOTE on page 2-16).

2. Unless the user sets the Max Xmit Unit, the WPIM-E1 automatically

sets the Max Xmit Unit to 8191 (default) after the active protocol

(PPP) is selected.

3. If the E1 Line Coding is HDB3 on the previous screen:

a. Use the arrow keys to highlight Line Coding. Press the

SPACEBAR to select None, then press ENTER.

b. Use the arrow keys to highlight Active Protocol. Press the

SPACEBAR to select PPP, then press ENTER.

c. Use the arrow keys to highlight PPP Type. Press the SPACEBAR

to select BNCP, then press ENTER.

4. If the E1 Line Coding is AMI on the previous screen:

a. Use the arrow keys to highlight Line Coding. Press the

SPACEBAR to select INV-HDLC, then press ENTER.

b. Use the arrow keys to highlight Active Protocol. Press the

SPACEBAR to select PPP, then press ENTER.

c. Use the arrow keys to highlight PPP Type. Press the SPACEBAR

to select BNCP, then press ENTER.

5. Use the arrow keys to highlight the SAVE command, then press

ENTER. The message “Save Done!” appears and Local Management

saves the changes to memory.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

No comments

Cabletron Systems BRIM-E6 Specifications Page 26