Bridging
4-58 Source Route Configuration
Figure 4-16. Source Route ConÞguration Window
Information on Source Routing
Source Routing is a bridging technique developed by IBM and the 802.5 standards
committee in which a bridge routes frames based on the contents of their media
access control frame header, rather than by maintaining a Þltering database to
determine whether a packet should be forwarded or Þltered. Source Routing
functions as follows:
¥ An end point station transmits discovery (explorer) frames to a particular
destination address in order to seek the best route through a bridged topology
to that node. These frames are broadcast over the entire network.
In a network topology with parallel bridges, multiple paths may be available
to the same destination. In this case, the explorer frame may be further deÞned
as:
- All Routes Explorer, so that all possible routes to the destination are
recorded, and multiple explorer frames can reach the same segment.
- Spanning Tree Explorer (also known as Single Route Broadcast), so that
only one path is possible to a segment (i.e., through a designated bridge in
a Spanning Tree topology), and only one explorer frame will be forwarded
onto each segment. The Spanning Tree can be conÞgured either
automatically (i.e., by algorithm) or manually.
Comments to this Manuals