Cabletron Systems CSX400 User's Guide Page 41
- Page / 150
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
CSX WPIMs 3-3
CSX200 and CSX400 WAN Configuration
as the backup. If the primary link should fail for some reason, the other WAN
interface will take over as the wide area link until the primary is restored.
When a WPIM-S/T is installed as the backup interface, that connection will
activate and provide an ISDN connection to the wide area network, if the primary
WAN link fails. The ISDN WPIM can also provide backup for single or multiple
Data Link Connection Interfaces (DLCIs). If a leased line loses a DLCI or a remote
ofÞce, for example, the WPIM-S/T will restore a 64K connection for that site while
the rest of the connections remain on the leased line. For more information on
WAN redundancy and the WPIM-S/T, consult your QuickSET documentation or
your hardware documentation.
CSX WPIMs
The following Cabletron WPIMs provide WAN connectivity for the CSX400,
HSIM-W84, and the CSX200 series. Currently Cabletron recommends that all
WPIM conÞguration be done through the QuickSET application that was shipped
with your device. Consult your QuickSET documentation for more details.
If there is a speciÞc device from the CSX200 series that supports the WPIM, it is
noted below. Otherwise, the WPIM can be special-ordered and installed in a
general CSX200 (contact the Cabletron Systems Global Call Center for more
information).
WPIM-DDS DDS is Digital Data Services, a digital network that
supports data rates of 56Kbps or 64Kbps. The DDS
service provides users with dedicated, two-way
simultaneous transmission capabilities operating at
transfer rates up to 64 Kbps. This WPIM comes with a
built-in CSX/DSU. (CSX203)
WPIM-DI The DI (Drop-and-Insert) WPIM provides a T1 interface
through a front-panel RJ45 port and includes a built-in
CSU/DSU for direct connection to a T1 line. The WPIM-
DI provides Full T1 or Fractional T1 using 56 or 64 Kbps
Time Slots. It also provides a second Drop-and-Insert
interface that allows more than one device, such as a
PBX, to share a single T1 connection. (CSX201)
WPIM-E1 This WPIM provides an E1 interface through a front-
panel RJ-45 port and includes a built-in CSU/DSU for
direct connection to an E1 line. This WPIM provides Full
E1 or Fractional E1 using 56 or 64 Kbps Time Slots with a
total throughput of up to 2 Mbps. Time Division
NOTE
The WPIM-S/T is designed for WAN ISDN redundancy only and is not intended to be
used for a primary WAN connection at this time.
- CSX200 and CSX400 1
- User’s Guide 1
- Virus Disclaimer 3
- Restricted Rights Notice 5
- Chapter 4 Bridging 8
- Contents 10
- Introduction 11
- HSIM-W6 and HSIM-W84 12
- Related Manuals 13
- Software Conventions 14
- Using the Mouse 15
- Using Window Buttons 16
- Getting Help 17
- CSX200 and CSX400 Firmware 18
- CSX200 and 400 Chassis View 19
- Viewing Chassis Information 20
- Front Panel Information 21
- Menu Structure 22
- The Chassis Manager Window 27
- Viewing Hardware Types 28
- Managing the Device 29
- 2-12 Managing the Device 30
- Managing the Device 2-13 31
- 2-14 Managing the Device 32
- Managing the Device 2-15 33
- 2-16 Managing the Device 34
- Managing the Device 2-17 35
- (Received only) 35
- (Received only) 35
- (Transmit only) 35
- Enabling and Disabling Ports 36
- Managing the Device 2-19 37
- 2-20 Managing the Device 38
- WAN Configuration 39
- About the CSX400 40
- CSX WPIMs 41
- 3-4 CSX WPIMs 42
- WAN Logical View 43
- Changing WAN Logical Settings 44
- WAN Logical View 3-7 45
- 3-8 WAN Logical View 46
- About Transparent Bridging 48
- About Source Route Bridging 48
- Bridging Basics 4-3 49
- 4-4 Bridging Basics 50
- Bridging Basics 4-5 51
- The Bridge Status Window 54
- The Bridge Status Window 4-9 55
- 4-10 The Bridge Status Window 56
- The Bridge Status Window 4-11 57
- 4-12 The Bridge Status Window 58
- The Bridge Status Window 4-13 59
- Bridge Statistics 61
- 4-16 Bridge Statistics 62
- Bridge Statistics 4-17 63
- 4-18 Bridge Statistics 64
- Bridge Statistics 4-19 65
- 4-20 Bridge Statistics 66
- Bridge Statistics 4-21 67
- 4-22 Bridge Statistics 68
- The CSMACD Statistics Window 69
- 4-24 Bridge Statistics 70
- Bridge Statistics 4-25 71
- 4-26 Bridge Statistics 72
- Bridge Statistics 4-27 73
- 4-28 Bridge Statistics 74
- Bridge Statistics 4-29 75
- 4-30 Bridge Statistics 76
- Bridge Statistics 4-31 77
- Source Route Statistics 78
- Bridge Statistics 4-33 79
- 4-34 Bridge Statistics 80
- Bridge Spanning Tree 81
- Bridge Level Fields 82
- Bridge Spanning Tree 4-37 83
- Bridge Port Level Fields 84
- Bridge Spanning Tree 4-39 85
- 4-40 Bridge Spanning Tree 86
- Bridge Spanning Tree 4-41 87
- Filtering Database 88
- Filtering Database 4-43 89
- 4-44 Filtering Database 90
- Filtering Database 4-45 91
- 4-46 Filtering Database 92
- Filtering Database 4-47 93
- 4-48 Filtering Database 94
- Bridging 100
- Changing the Receive Ports 101
- Source Route Configuration 103
- Information on Source Routing 104
- Making and Setting Changes 109
- Setting the Aging Time 111
- Duplex Modes 112
- The Duplex Modes Window 113
- 4-68 Duplex Modes 114
- Duplex Modes 4-69 115
- SONET Port Configuration 120
- SONET Port Configuration 4-75 121
- SONET/SDH Statistics Window 122
- 4-78 SONET Port Configuration 124
- SONET Port Configuration 4-79 125
- 4-80 SONET Port Configuration 126
- SONET Port Configuration 4-81 127
- Token Ring Bridge Mode 129
- Defining the Bridge Modes 130
- Defining the Bridge Method 136
- Setting the Bridge Method 137
- Configuring SmartTrunking 142
- Configuring SmartTrunking 4-97 143
- 4-98 Configuring SmartTrunking 144
- Configuring SmartTrunking 4-99 145
Related products and manuals for Networking Cabletron Systems CSX400
(74 pages)
(310 pages)© 2020, manymanuals.com. All rights reserved. | 1.129 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals