Cabletron Systems CyberSWITCH CSX500 Specifications download pdf (Page 102)

Configuration with QuickSET

86 QuickSET Configuration Guide

This section describes the ﬁelds in the Wide Area HDSL conﬁguration window.

HDSL Transmit Clock Source — Displays the HDSL Transmit Clock Source. Click on the radio

button to select either the Slave or Master option. The default setting is Slave.

Protocol — The Protocol panel lets you select one of four protocols: Point-to-Point, HDLC

(High Level Data Link Control), Frame Relay Point-to-Point, Frame Relay Point-to-Multipoint.

High Level Data Link Control lets you select either Full or Fractional mode for all or half of the

time slots (for a single interface number and alias). Point-to-Point protocol lets you select an

interface number for each time slot. Frame Relay Point-to-Multipoint allows only one interface

number and alias, but allows multiple DLCIs. Frame Relay Point-to-Point allows multiple

interface numbers, aliases, and DLCIs.

Link Management Protocol — If Frame Relay is the selected protocol, this ﬁeld displays Q.933

Annex A and T1.617 Annex D. The default for Frame Relay is T1.617 Annex D. This ﬁeld is

grayed out and not used for PPP.

DLCI Button — The DLCI Setup button displays the DLCIs window shown below in Figure 94.

The DLCIs window shows a list of Interface Numbers, Aliases, and DLCIs (Data Link Connection

Identiﬁers). Use the Add button and the Add DLCI window (Figure 95) to make new entries to

this table. Use the Delete button to delete the entry highlighted. Click Done when you have

ﬁnished.

Figure 94 DLCIs Window

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 163 164

No comments

Cabletron Systems CyberSWITCH CSX500 Specifications Page 102