Cabletron Systems CyberSWITCH CSX500 Specifications download pdf (Page 47)

Bridging and Routing Configuration

QuickSET Configuration Guide 31

Bridging and Routing Conﬁguration

When you have collected all the necessary network information for the WAN, your

CyberSWITCH or HSIM can be conﬁgured for inverse multiplexing or bridging and/or routing.

Bridging and Routing Conﬁguration Window

The ﬁrst Bridging and Routing conﬁguration window shown in Figure 30 displays after clicking

on the N

ext>> button at the bottom of the General Configuration window. Figure 31 shows the

Bridging and Routing conﬁguration window for an HSIM-W84 or CSX500.

Figure 30 Bridging and Routing Conﬁguration Window for HSIM-W6

If you are conﬁguring an HSIM, you will have a single External HSIM Network # window in

place of the two External Ethernet 1, and 2 windows at the right of the panel. The panel is identical

in all other respects. The following section describes the ﬁelds in the ﬁrst Bridging and Routing

conﬁguration window.

Inverse Mux (Multiplex) Conﬁguration — [The CSX200 does not support IMUX] This

function lets you balance your LAN trafﬁc between two or four T1 WAN ports, and is used with

Point to Point Protocol (PPP) or HDLC protocol. QuickSET automatically sets the WAN Frame

Type to Encapsulated Ethernet when you use the Inverse Mux conﬁguration. When you select the

Inverse Mux check box, bridging, IP routing, and IPX routing functions are all disabled. The

WAN device at the other end of the WAN link(s) must be a Cabletron Systems device, capable of

receiving the balanced WAN trafﬁc.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 163 164

No comments

Cabletron Systems CyberSWITCH CSX500 Specifications Page 47