Cabletron Systems CyberSWITCH CSX500 Specifications download pdf (Page 124)

Configuration with QuickSET

108 QuickSET Configuration Guide

Figure 118 Modify Backup Window

The following are deﬁnitions of Dial-Up Settings parameters:

Time to Connect — Time to Connect lets you conﬁgure the seconds to wait, before attempting to

switch over to the back-up interface. The default is zero. Allowed values are in increments of ﬁve

seconds, to a maximum of 10,000 seconds.

Time to Disconnect — Time to Disconnect allows you to conﬁgure the amount of seconds the

restored primary interface must remain connected, before attempting to switch over from the

back-up interface. The default value is 90 seconds. Allowed values are in increments of ﬁve

seconds, up to a maximum of 10,000 seconds. A value of zero is acceptable.

Connect Retries — Connect Retries allows you to conﬁgure the number of tries to restore the

back-up interface, before giving up. The default value is three. Allowed values are in increments of

one, up to a maximum of 10,000. A value of zero is acceptable.

Retry Interval — Retry Interval lets you set up the time between retries (maximum 60 seconds).

Override Primary Connection — Override Primary Connection forces the back-up interface to

remain connected, and does not allow the back-up interface to switch back to the primary

interface, even if the primary interface is restored.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 163 164

No comments

Cabletron Systems CyberSWITCH CSX500 Specifications Page 124