Cabletron Systems CyberSWITCH CSX500 Specifications download pdf (Page 56)

Configuration with QuickSET

40 QuickSET Configuration Guide

Routing Conﬁguration Window

The (IP/IPX) Routing conﬁguration window shown in Figure 38 below, displays after clicking on

the N

ext>> button in the second Bridging and Routing (WAN Frame Type) conﬁguration window.

Figure 38 Routing Conﬁguration Window

The next section describes the ﬁelds in the (IP/IPX) Routing conﬁguration window. Refer to the IP

Routing Configuration section to conﬁgure your CyberSWITCH or HSIM for IP routing.

Otherwise, refer to IPX Routing Conﬁguration section to conﬁgure your CyberSWITCH or

HSIM for IPX routing.

IP Routing Conﬁguration

This section describes the ﬁelds in the IP Routing Conﬁguration portion of the Routing

conﬁguration window.

Interface # — Displays an interface number assigned an IP subnet.

Remote LAN Subnet — Displays the IP subnet assigned to the interface number.

Subnet Mask — Displays the Subnet Mask assigned to the interface number.

Next Hop — The Next Hop is the IP address of the IP port of the next router (in the direction of

the subnet that you are deﬁning).

Default Route... — Displays the Default Route window. You can select one interface to be a

default route. A default route forwards all packets that are not deﬁned in the routing table to the

interface deﬁned in the Default Route window (Unnumbered Routing Only). To set up a default

route in “Numbered Mode” communication, click the Add Route button and enter IP Subnet

000.000.000.000, and Subnet Mask 255.255.255.255. Then use the NEXT HOP window to enter

the IP Address of the router you wish to designate as the default route.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 163 164

No comments

Cabletron Systems CyberSWITCH CSX500 Specifications Page 56