Cabletron Systems CyberSWITCH CSX500 Specifications download pdf (Page 140)

Configuration with QuickSET

124 QuickSET Configuration Guide

When Split Horizons is OFF (disabled) for any of the above protocols, all protocol information

received on that port will be rebroadcast back out that port, for example, to allow other DLCIs

(Data Link Connection Identiﬁers) on this port, that have not received these packets, to receive this

information. The Modify window shown in Figure 134 on the previous page, displays after you

have selected an Interface Number and clicked on the M

ODIFY button.

Advanced IP Routing Options

Redirector Window

The Redirector window shown in Figure 135 below, displays after clicking on the Redirector...

button in the Advanced Routing conﬁguration window. The Redirector window is used to set up an

IP address for a remote Dynamic Host Conﬁguration Protocol (DHCP) server.

Figure 135 Redirector Window

NAT Settings Window

The NAT Settings conﬁguration window shown in Figure 136 on the following page, displays

after clicking on the NAT Settings. button in the Advanced Routing conﬁguration window. The

NAT Settings window is used to set up Network Address Translation on Ethernet ports 1 and 2.

Note: If your conﬁgurable device uses version 2.01.XX ﬁrmware, you can specify any valid

IP Address as the address that you advertise as your “public” IP Address.

If your conﬁgurable device uses version 1.00.XX, or version 2.00.XX ﬁrmware, your public

IP Address will be the IP Address that you are running Network Address Translation to.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 163 164

No comments

Cabletron Systems CyberSWITCH CSX500 Specifications Page 140