Cabletron Systems CyberSWITCH CSX500 Specifications download pdf (Page 28)

Configuration with QuickSET

12 QuickSET Configuration Guide

Link Management Protocol — If you selected Frame Relay protocol, this ﬁeld displays

Q.933 Annex A, or T1.617 Annex D. The default is T1.617 Annex D. This ﬁeld is grayed out and

not used for PPP.

When you have completed conﬁguration, click on the N

ext>> button and go to the Wide Area

Frame Relay Time Slot Configuration Window or Wide Area PPP Time Slot Configuration

Window section, depending on which protocol you are using.

Wide Area DI Conﬁguration Window

The Wide Area (DI) conﬁguration window is shown in Figure 10 below.

The following section explains how to conﬁgure the Wide Area DI interface using QuickSET.

Figure 10 Wide Area DI Conﬁguration Window

The line conﬁguration information given below and on the following pages must be supplied by

your service provider. The factory default settings are in bold.

The WPIM-DI has two connectors allowing two devices to share the available Time Slots in a T1

WAN link; an NI (Network Interface) Port, and a DI (Drop and Insert) Port.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 163 164

No comments

Cabletron Systems CyberSWITCH CSX500 Specifications Page 28