Cabletron Systems CyberSWITCH CSX500 Specifications download pdf (Page 91)

Wide Area - 1 and 2 Configuration Windows

QuickSET Configuration Guide 75

High Level Data Link Control lets you select either Full or Fractional mode for all or half of the

time slots (for a single interface number and alias). Point-to-Point protocol lets you select an

interface number for each time slot. Frame Relay Point-to-Multipoint allows only one interface

number and alias, but allows multiple DLCIs. Frame Relay Point-to-Point allows multiple

interface numbers, aliases, and DLCIs.

Link Management Protocol — When you select Frame Relay, this ﬁeld displays

Q.933 Annex A, T1.617 Annex D, and T1.617 Annex D 1994. The default for Frame Relay is

T1.617 Annex D. This ﬁeld is grayed out and not used for PPP.

DLCI Setup Button — The DLCI Setup button displays the DLCIs window shown in Figure 81

on the following page. The DLCIs window shows a list of Interface Numbers, Aliases, and DLCIs

(Data Link Connection Identiﬁers). Use the Add button and the Add DLCI window to make new

entries to this table. Use the Delete button to delete the entry highlighted. Click Done when you

have ﬁnished.

Figure 81 DLCIs and Add DLCI Windows

When you have completed E1 WAN conﬁguration, click on the Next>> button and go to the Wide

Area Time Slot Configuration Windows section, for the appropriate time slot window.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 163 164

No comments

Cabletron Systems CyberSWITCH CSX500 Specifications Page 91